Where do I extract the EEA reports?

The EEA Reports (EEA 2, EEA 2 Details, EEA 4, EEA 4 Details) can be extracted from the Legislative report category under the Standard (Classic) reports tab.

      Navigate > Reports > Reports > Standard (Classic) > Legislative

      

      

Note! These reports must be extracted for a twelve-month period. The report will return blank, should it be extracted for a period of less than twelve months.

• Related Articles

• Why are certain employee's excluded from the EEA Statutory Reports?

  Employees may be excluded from the EEA Statutory Reports (i.e. the EEA2 and EEA4 Reports) due processing errors on the payroll. These errors need to be rectified for the employees to be included in these reports. ...

• Why is there information missing on the EEA2 Details report?

  The Employment Equity reports require extensive system configurations in order for the relevant information to pull through on the EEA reports. Refer to the attached guide on how to configure the system so that all the relevant information is ...

• How do I exclude an employee from the EEA Reports?

  To exclude an employee from the EEA reports, enable the "Exclude from the EEA Report " checkbox under the Exemptions and Other section on the Employee tab on the Basic Profile screen. Navigate > Employee > Basic Information > Basic Profile > Employee ...

• How should the Employment Equity Config screen be setup?

  In order for the EEA4 Statutory Report to generate the remuneration accurately, the components that need to be included should be indicated on the Employment Equity Config screen. Note! This needs to be set-up per frequency. There are four ...

• How do I compare the EEA Report Targets vs the Actual results?

  Make use of the following steps to compare the EEA Report Targets vs the Actual results. Navigate > Configuration > Human Resources > Employment Equity > Employment Equity Plan Step 1: Select the view as Target. Step 2: Complete the parameters on the ...