Why are certain employee's excluded from the EEA Statutory Reports?
Employees may be excluded from the EEA Statutory Reports (i.e. the EEA2 and EEA4 Reports) due processing errors on the payroll. These errors need to be rectified for the employees to be included in these reports. why-are-certain-employees-excluded-from-the-eea-statutory-reports
Apply a filter to the column, Exceptions Not Reported On (column U), on the EEA2 and EEA4 Detail Reports, to review if there may have been any
processing errors that need to be rectified on the payroll.
Navigate > Reports > Reports > Reports (Classic) > Legislative > EEA Reports
Set the filter on "Yes", which return employee information based on the following conditions:
Important! Refer to the attached Employment Equity manual for a detailed guide.
Related Articles
Why is there information missing on the EEA2 Details report?
The Employment Equity reports require extensive system configurations in order for the relevant information to pull through on the EEA reports. Refer to the attached guide on how to configure the system so that all the relevant information is ...Where do I extract the EEA reports?
The EEA Reports (EEA 2, EEA 2 Details, EEA 4, EEA 4 Details) can be extracted from the Legislative report category under the Standard (Classic) reports tab. Navigate > Reports > Reports > Standard (Classic) > Legislative Note! These reports must be ...How should the Employment Equity Config screen be setup?
In order for the EEA4 Statutory Report to generate the remuneration accurately, the components that need to be included should be indicated on the Employment Equity Config screen. Note! This needs to be set-up per frequency. There are four ...How do I exclude an employee from the EEA Reports?
To exclude an employee from the EEA reports, enable the "Exclude from the EEA Report " checkbox under the Exemptions and Other section on the Employee tab on the Basic Profile screen. Navigate > Employee > Basic Information > Basic Profile > Employee ...How do I correct the system if the "terminated for statutory reporting"was not enabled during the employee transfer process so that the EEA reports are correct?
When transferring an employee the "terminated for statutory reporting" field on the Transfer screen needs to be considered. Only select this field, when transferring employees between companies with different Employment Equity reference numbers. ...