How do I configure a component's decimal place value?

A component's decimal place value can be configured when editing it on the General Ledger Parameters screen.

      Navigate > Configuration > Payroll > Payroll Config > General Ledger Parameters

      

Note! Set the decimal place value to "0" to remove the decimal places.

• Related Articles

• Why do I receive the following error "GL will not balance. A payroll component has not been allocated a GL String." when trying to upload the general ledger?

  The error "GL will not balance. A payroll component has not been allocated a GL String" is a general error produced by the system if any Allowance/Deduction/Company Contribution component has a payslip value but has not been mapped to a GL account ...

• Payroll Components | Editing a Component

  Overview Payroll Components may be edited or reconfigured by selecting the "Edit" hyperlink on the right hand side of the applicable component, which will open a screen with numerous options. Edition This feature is available on all PaySpace ...

• How do I add and edit general ledger account codes?

  The GL Account and GL Contra Account codes (numbers) can be added and edited per component on the General Ledger Parameters screen. Edit the applicable GL Account and GL Contra Account codes listed next to applicable component. Navigate > ...

• Can I change the name of the default general ledger?

  The naming convention of the Default General Ledger cannot be changed. Navigate > Configuration > Payroll > Payroll Config > General Ledger Parameters

• How do I prevent a component from reflecting on the PDF payslip?

  There are two options to prevent components from reflecting on the PDF payslip: Option 1: Edit the component and enable the "do not show on payslip:" check box under "extra options" on the Payroll Components screen. Navigate > Payroll > Payroll ...